自動補膠電氣的維護程序！
自動補膠電氣維護程序
Electrical Maintenance Procedure for Automatic Glue Repairing
檢查重要傳動裝置及PLC+觸摸屏的工作狀態，及時清理冷卻風機上的灰塵，檢查有無損壞的協商回路。
Check the working status of the important transmission device and PLC + touch screen, clean up the dust on the cooling fan in time, and check the negotiation circuit without damage.
機器的操作直接記錄了事情
The operation of the machine records things directly.
1. 開機前檢查電源，檢查氣源是否符合機器要求。電源:220V，氣源:大0.5mpa。
1. Check the power supply before starting, check whether the air supply meets the requirements of the machine. Power supply: 220V, gas source: maximum 0.5mpa.
2. 如果機器電路出現故障，只能根據電路圖解決(用戶必須接受過培訓或電工)。
2. If the machine circuit breaks down, it can only be solved according to the circuit diagram (the user must have received professional training or professional electrician).
3參數的轉換時間必須是AB膠不允許按下，直到參數沒有問題，才可以實際澆注膠。
The conversion time of parameters must be that AB glue is not allowed to be pressed until the parameters are not in question before the actual casting glue can be poured.
4. 比例調整后，單位板的分散度有不同數量的膠水，如果之前的參數是穩定的，好做實際的膠水，以確保優良的固化。
4. After adjusting the proportion, the dispersity of the unit plate has different amount of glue. If the previous parameters are stable, it is better to make actual glue to ensure excellent curing.
5. 用你的手觸摸機會的移動部分，即使斷電。
5. Touch the moving part of the opportunity with your hand, even if the power is off.
6. 調動B膠時，更換前必須先解除B膠筒的壓力。
6. When transferring B-glue, the pressure of B-glue cylinder must be relieved before replacing it.
7. 不允許在無意中改變均勻性參數。如果您需要更改膠水比例，請在頁更改。
7. It is not allowed to change the uniformity parameter unintentionally. If you need to change the glue ratio, please change it on the first page.
8. 不要讓AB泵在沒有膠水的情況下在AB橡膠桶內變形，以免損壞泵體。
8. Don't let AB pump deform in AB rubber barrel without glue, so as to avoid damaging the pump body.
9. AB橡膠桶下球閥處于開啟狀態。
9. The ball valve under AB rubber drum is open.
上一篇：自動灌膠機的操作守則！
下一篇：打膠機市場分析主要包括哪些點？
